Scene File Operations; Saving Set Data - Panasonic AJ-RC5 Operating Instructions Manual

Scene File Operations

When the VTR/SCENE enable switch has been set to SCENE, the S1 button, S2 button, S3
button, S4 button, SAVE button and LOAD button can be used to store the data that has been
adjusted by the unit in the unit's memory as scene files.
Saving the set data
Example: Saving data into scene No.1
1 Select the scene number for
which the data is to be saved.
1 Press the S1 button.
REW
S1
STOP
PLAY
S3
The selected scene No. button now blinks.
<Notes>
≥ To change to another scene No., simply press
the button that corresponds to that scene No.
≥ To release the scene No. selection, press the
scene No. button which is now blinking again.
2 Save the setting data.
1 Press the SAVE button within 10 seconds
of performing the operation in 1-1.
REW
S1
STOP
PLAY
S3
Both the selected scene No. button and SAVE
button start blinking.
START/STOP
FF
S2
SAVE
REC CHK
LOAD
S4
START/STOP
FF
S2
SAVE
REC CHK
LOAD
S4
2 Again press the SAVE button within 10
seconds of performing the operation in 2-
1.
REW
S1
STOP
S3
While the data is being saved, both the selected
scene No. button and SAVE button stop
blinking and come on.
REW
S1
STOP
S3
The save operation is completed when the
SAVE button goes off, the scene No. button
used to save the data stays on and the LOAD
button comes on.
<Note>
After the data has been written in the memory,
the operation mode (scene mode) prescribed
by the saved scene data is established, and the
KNEE SLOPE, KNEE POINT, DETAIL,
GAMMA and M.PED VR control operations
differ slightly from their regular operations. For
further details, refer to the section entitled
"Operation mode established by scene file data
<scene mode>."
E-9
START/STOP
FF
S2
SAVE
PLAY
REC CHK
LOAD
S4
START/STOP
FF
S2
SAVE
PLAY
REC CHK
LOAD
S4