Sony PCM-7040 Operation Manual page 47

5-1 Playback
To reset an IN or OUT point to "0", press the
DATA key while holding down the RESET
key.
The data for all digits is reset to "0".
(4) Press the SET key.
The display stops flashing and setting
terminates.
3
Press the LOCATE key while the IN or OUT point
(set as described above) is displayed.
The LOCATE indicator lights and the unit plays
back the portion between the IN and OUT point 16
times.
After starting playback, "rEPEAt PLAy**" is
displayed. (** indicates the number of times the
portion is to be played back.)
If you press the LOCATE key and either the IN point
or OUT point is invalid, the start and end points of the
playback will be as follows.
If the IN point is invalid, the playback will start from
the beginning of tape.
If the OUT point is invalid, playback will end at the
end of tape.
Start ID search operation—Start ID locate
This section explains how to search for a Start ID that
has been recorded on the tape beforehand.
When you perform ID locating, the unit indicates both
the number of the Start ID to be located and the current
Program number on the display.
See section "Writing and Erasing Start ID/Skip ID/End ID"
(page 4-10) for how to write the Start ID.
Selecting the types of Start ID locate
You can select the following types of start ID locate
from the setup menu.
• The unit locates the previous or next start ID upon
detecting a skip ID during playback.
Set this from the setup menu "Auto StoP".
• Locating a start ID automatically upon inserting a
cassette
Set this from the setup menu "Auto SrcH".
• Locating a position ahead of the point where the ID is
recorded
Set this from the setup menu "PrEroLL".
5-4
Chapter 5 Playback
Start ID locating procedure
START ID PREVIOUS key
START ID NEXT key
Press the START ID NEXT key to locate the start ID
in the forward direction.
Press the START ID PREVIOUS key to locate the
start ID in the reverse direction.
When you press the key once, this unit moves to the
next or previous start ID and stops.
When you press the key twice, this unit moves to the
second start ID and stops.
* * * * * *
If you perform the Start ID locate fuction in memory
start mode (with the MEMORY START indicator
blinking), the unit stores the sound around the locate
point to sound memory and enters memory start
standby mode.
To start playback right after locating to the point
Press the PLAY key with the START ID NEXT or
PREVIOUS key, or while the unit is searching for the
point.
Program number/End ID search operation
—Program number/End ID locate
3
Number of Start ID to locate
Current Program number
1
2