Craftsman 81338 Operator's Manual page 4

operatioN
removiNG aND iNstalliNG DraWers
• Empty the drawer.
• Fully extend the drawer.
Figure 6
ball beariNG sliDes
lever style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops.) Pull out to remove.
tab style - depress the release tabs on both sides,
(this allows the slides to ride over the stops).
Pull out to remove.
Release Left
Release Right
friction style - Fully extend the drawer. insert screwdriver
into the slot in the side and push in on the stop until it
clears the lance. Pull drawer just past lance before
releasing stop. Repeat the process for the other slide.
friction slide - Fully extend slides in cabinet. Hold the
slide on the cabinet while aligning it with the slide on
drawer. Push the drawer into the unit until the drawer
fully engages slides. Open drawer and reclose to ensure
proper operation. (if stop does not engage slide, lightly
deflect the stop with screwdriver.)
Slide
Stop