Opening The Device And Loosening Cables - Siemens INOX PRO SIMATIC IPC277D Service Manual

Extended maintenance work

4.2 Opening the device and loosening cables

4.2 Opening the device and loosening cables
Requirement
● The device has been removed from the stand or support arm.
● The connection cables have been removed from the device interfaces.
● Required tool: Allen wrench, size 8 mm
Procedure
1. Place the device on its front. Use a soft and elevated surface so that the front operator
controls do not contact the working area and are not damaged.
2. Remove the 20 screws that connect the rear panel with the device front.
3. Lift the rear panel on the right and fold it back to the left, as shown in the figure below.
Make sure that the rear panel seal remains in the device front.
12
SIMATIC IPC277D 19" INOX PRO, SIMATIC IFP1900 INOX PRO
Service Manual, 03/2015, A5E35751762-AA