Changing The Mounting Type - Siemens INOX PRO SIMATIC IPC277D Service Manual

4.5

Changing the mounting type

This section describes the conversion of a stand-mounted device into a support arm device.
The conversion of a support arm device into a stand-mounted device takes place in the
same manner.
Procedure
1. Swap the position of the front and rear panel as shown in the figure below.
2. Turn the rear panel by 180°.
3. Remove the adhesive tape (X) of the flat ribbon cable as shown in the figure below.
4. Place the flat ribbon cable from the front on the rear panel, and attach the adhesive tape
(X) in its original position as shown in the figure below.
SIMATIC IPC277D 19" INOX PRO, SIMATIC IFP1900 INOX PRO
Service Manual, 03/2015, A5E35751762-AA
Extended maintenance work
4.5 Changing the mounting type
19