Download Print this page

Servicing Procedures; Specification - Hitachi CL-8330BF Instructions Manual

Advertisement

LAYERING AND SHAPING
1.Thinning (entire head)
(1) Comb hair to desired style.
(2) Lightly move the clipper from top to bottom as if combing the hair. (Fig.44.18)
By keeping one hand underneath the hair while cutting with the unit, there is little chance of cut
hair getting in the face.
Do not thin hair near top of head since short hair will stand up.
If person has a lot of hair, take up a portion of hair in hand and thin hair beneath hand. (Fig.45)
2.Cutting of crown
Pull up hair between fingers directly perpendicular to top head and slowly run the clipper above
fingers to cut. (Fig.46.20)
To ensure cutting at the same length, take up hair already cut together with hair to be cut and
cut latter to the same length as the former.
3.Layering and shaping
(1) Lift up hair from the bottom with a comb.
(2) Hold comb firmly in place and cut hair in direction of arrow. (Fig.47.20)
Do not try to cut a lot of hair at once.
Cut a little at a time.
Always comb hair cutting and trim
has been done properly.
4.Cutting around ears
Put the cutter lightly against the skin and move it in a circle in the arrow direction. (Fig.48.22)
Hold the ear by hand to facilitate the job.
5.Side cutting (evening up the sides)
Put the cutter at right angle to the skin to trim the hair. (Fig.49.24)
6.Shaving downy hair
Put the cutter directly on the skin and shave the downy hair working from the lower to the
upper part of the neck. (Fig.50.26)
Do not press the cutter too hard.
7.Finishing the whole head
Comb entire head. Even out any rough parts by using the clipper set for thinning. (Fig.51.28)

SERVICING PROCEDURES

Always clean out hair and lubricate the cutter after use.
1. Always turn switch to "OFF" before servicing the unit.
2. Use accessory cleaning brush to clean out hair from the unit and around cutter. (Fig.52)
3. Open the blade from the clipper and clean out hair from the inside. (Fig.53)
4. Lubricate the cutter with a few drops of oil.
Store the clipper in a dry place.
This mark means that the appliance is not
washable.

SPECIFICATION

Power supply Power adaptor
(KH-185B)
Main body
Charging time
Weight
Accessories
Cord length
portion while checking that cutting
100-240V AC 50-60Hz
Ni-MH battery (DC 1.2V, 950mAh × 2)
5 hours (Standard)
Body : Approximately 155g
Cropped hair attachment, Cleaning brush, Lubrication oil
1.8 m
-6-
Power adaptor : Approximately 100g

Advertisement

loading