Advertisement
When any trouble occurs during use, disconnection the use, and make sure of the following points
before asking a repair.
Symptom
Sharpness is not good.
Rotation is weak.
Charging is not
available.
The clipper is out of
charge. It does not
work even through the
cord is connected.
Charging is not available.
Does not work.
PLEASE NOTE WHEN DISPOSING OF THE PRODUCT
Keep the removed battery out of the reach of children.
If a child appears to have swallowed a battery, immediately seek medical attention. If the battery
electrolyte leaks, do not touch it with bare hands but take the following action.
If electrolyte gets into eyes, do not rub eyes but immediately rinse with clean water and then seek
medical attention.
If electrolyte adheres to the body or clothing, sufficiently rinse with clean water and then seek
medical attention.
Never disassemble except when disposing of the product. (Cause of fires, electric shocks, or injury)
The battery is to be disposed of safely.
In accordance with current recycling legislation, do not dispose of the battery contained in this appliance
with normal household waste. When recharging can no longer be effected, please dispose in the
method advised by your local area council.
HOW TO REMOVE THE NICKEL METAL HYDRIDE BATTERY
Remove the battery before disposing of the appliance.
1. Disconnect the power adaptor from the appliance when removing the battery.
2. Keep the switch at on until the shaver stops moving completely to discharge the battery.
3. Remove the cutter.
4. With the switch at " OFF " remove the 1 (+) screw from the body, and remove the front case.
(Fig. 54)
Screw
5. Take the battery out of the main body, cut the lead wires of the battery near the terminals. (Fig. 55)
Lead wires
Battery
Never allow the (+) and (-) terminals of the removed battery to make contact.
(Cause of short circuits or burns)
Points to be checked
A great deal of hair cuttings are
accumulated inside the cutter.
The switch is set to on.
The cord is connected with the
switch set to on.
The cord is interrupted. Is not the
service life of Ni-MH
battery, cutter or motor over?
Front case
Terminal
-7-
Remedy
Periodically clean up and
lubricate.
Turn the switch "OFF" and
begin charging.
Turn the switch "OFF" and
use after waiting for a while.
Ask a shop where you have
bought, to repair.
Advertisement
