Table of Contents
Advertisement
6 Maintenance and care
General information
The service life of the appliance will extend
and the possibility of problems will decrease
if the appliance is cleaned at regular
intervals.
DANGER: Disconnect the product
from mains supply before starting
maintenance and cleaning works.
There is the risk of electric shock!
DANGER: Allow the product to
cool down before you clean it.
Hot surfaces may cause burns!
Clean the product thoroughly after each
use. In this way it will be possible to
remove cooking residues more easily, thus
avoiding these from burning the next time
the appliance is used.
No special cleaning agents are required
for cleaning the product. Use warm water
with washing liquid, a soft cloth or sponge
to clean the product and wipe it with a dry
cloth.
Always ensure any excess liquid is
thoroughly wiped off after cleaning and
any spillage is immediately wiped dry.
Do not use cleaning agents that contain
acid or chloride to clean the stainless or
inox surfaces and the handle. Use a soft
cloth with a liquid detergent (not abrasive)
to wipe those parts clean, paying attention
to sweep in one direction.
Annual servicing by an authorised person
is recommended. If the appliance
produces unusual odour, yellow tipping
flame, flame lifting off the burner or is not
performing as per the original installation,
or for service contact: Beko A and NZ Pty
Ltd 1300 282 356.
Page 20
The surface might get damaged
by some detergents or cleaning
materials.
Do not use aggressive detergents,
cleaning powders/creams or any
sharp objects during cleaning.
Do not use harsh abrasive
cleaners or sharp metal scrapers
to clean the oven door glass since
they can scratch the surface,
which may result in shattering of
the glass.
Do not use steam cleaners to
clean the appliance as this may
cause an electric shock.
Cleaning the hob
Gas hobs
1. Remove and clean the saucepan carriers
and burner caps.
2. Clean the hob.
3. Install the burner caps and make sure that
they are seated correctly.
4. When installing the upper grills, pay
attention to place the saucepan carriers
so that the burners are centered.
Cleaning the control panel
Clean the control panel and knobs with a
damp cloth and wipe them dry.
Do not remove the control
buttons/knobs to clean the control
panel.
Control panel may get damaged!
Advertisement
Table of Contents
