Functional Description - Black & Decker BDCSMCA Instruction Manual

SYMBOLS
The label on your tool may include the following
symbols. The symbols and their definitions are
as follows:
V .................. volts
A .................. amperes
Hz ................ hertz
W ................. watts
min .............. minutes
or AC ...... alternating current
or DC ... direct current
n o ................ no load speed
................ Class I Construction
................ earthing terminal
(grounded)
............... safety alert symbol
................ Class II Construction
(double insulated)
.../min or rpm... revolutions or
reciprocation per minute
............ Read instruction manual before use
................ Use proper respiratory
protection
................ Use proper eye protection
................ Use proper hearing protection
When using an extension cord, be sure to use
one heavy enough to carry the current your
product will draw. An undersized cord will cause
a drop in line voltage resulting in loss of power
and overheating. The following table shows the
correct size to use depending on cord length
and nameplate ampere rating. If in doubt, use
the next heavier gauge. The smaller the gauge
number, the heavier the cord.
Minimum Gauge for Cord Sets
Volts
120V 0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
Ampere Rating
More Not more
Than Than
0 - 6 18
6 - 10 18
SAVE THESE INSTRUCTIONS
WARNING:
Before attempting any of
the following operations, make sure the
forward-reverse switch of the screwdriver is set
to the center postion so the screwdriver cannot
turn on.

FUNCTIONAL DESCRIpTION

(FIGURE A)
1. Collar
2. Blade
3. Upper guard
4. Lower guard
Total Length of Cord in Feet
26-50 51-100 101-150
American Wire Gauge
16 16
16 14
A
OpERATING INSTRUCTIONS
WARNING:
injury, make sure the cutter blade has stopped,
and the forward/reverse switch on your
screwdriver is in the center, locked position.
before making any adjustments or removing or
installing attachments or accessories.
WARNING:
away from blade.
WARNING:
protection that conforms to ANSI Z87.1(CAN/
CSA Z94.3) while operating this power tool.
NOTE: Before cutting any type of material,
be sure it is firmly anchored or clamped to
prevent slipping.
Assembly (figures b - f)
• Remove the rubber ring (5) from your
screwdriver (Figure B).
NOTE: Rubber ring is not included on all
screwdrivers.
14
12
• Align arrows
notches (7) (Figure C).
CAUTION
secured. DO NOT turn screwdriver on with
the attachment in this position.
3
2
To reduce the risk of
Cut hazard. Keep fingers
Always use proper eye
B
(6) with the screwdriver
C
6
7
: The attachment is not yet fully
1
3
4
5