Panasonic U-8MF2E8 Service Manual page 115

3-way vrf system
Table of Contents

Advertisement

2. Detailed Settings Function
Item code
Item
10
Unit type
11
Indoor unit capacity
System (outdoor unit)
12
address
13
Indoor unit address
14
Group address
Cooling intake temperature
17
shift
Automatic stop time after
18
operation start
Cooling discharge
1C
temperature shift
Heating discharge
1d
temperature shift
Temperature shift for
1E
cooling/heating change in
"auto heat/cool" mode
Cooling temperature setting
Remote controller temperature setting
Heating temperature setting
Set when the indoor unit EEPROM memory is replaced during servicing.
These are not set at the time of shipping from the factory.
These must be set after installation if automatic address setting is not
performed.
Shifts the intake temperature during cooling and dry operation.
(Enabled only when the body thermostat is used.)
Increase this value when it is difficult to turn the thermostat ON.
The time at which an indoor unit is automatically stopped after operation starts
can be set in increments of 5 minutes.
Shifts the set value for models which perform discharge temperature control.
(Discharge temperature control models: Floor discharge, wall built-in, direct
expansion coil outdoor air treatment, high-fresh)
"Auto heat/cool" selects the operating mode automatically based on the
difference between the room temperature and the temperature set on the
remote controller. This setting establishes a shift temperature for the heating/
cooling temperature setting relative to the remote controller temperature
setting.
Shift temperature
(+)
Shift temperature
(–)
4 - 13
3WAY SYSTEM
Remote Controller Functions
Description
4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents