Troubleshooting; Setup And Configuration Problems - D-Link DWR-922 Quick Installation Manual

TROUBLESHOOTING

SETUP AND CONFIGURATION PROBLEMS

1. HOW DO I CONFIGURE MY DWR-922 ROUTER OR CHECK MY WIRELESS NETWORK
NAME (SSID) AND WIRELESS ENCRYPTION KEY?
- Connect your PC to the router using an Ethernet cable.
- Open a web browser and enter the router's IP address: http://192.168.0.1 into the address bar.
- Log into the router using the default username admin. By default, the password is left blank.
- Once logged in, you can use the wizard to configure the router, or make changes manually.
Note: If you have changed the password and cannot remember it, you will need to reset the
router to factory defaults. The default SSID and password are printed on the bottom of your
router.
2. HOW DO I RESET MY DWR-922 ROUTER TO FACTORY DEFAULT SETTINGS?
- If you cannot remember your router administrator password, you may use an implement such as
a straightened paperclip to press and hold the reset button on the front of the router for about
10 seconds.
Note: Resetting the router to factory default settings will erase the current configuration. To
reconfigure your router, log in as outlined in question 1, then run the Setup Wizard.
3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY
WIRELESS NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?
- For every PC that needs to connect to the router wirelessly, you will need to ensure you use the
correct Wireless Network Name (SSID) and encryption key.
- Use the web-based user interface (as described in question 1 above) to check or choose your
wireless settings.
- Make sure you write down the SSID and password so that you can enter them into each
wirelessly connected PC. You will find a dedicated area on the back of this document to record
this important information for future use.
4. WHY AM I UNABLE TO ESTABLISH AN INTERNET CONNECTION?
- If connecting using a 4G mobile connection, make sure that you are within range of the mobile
service provider, and that the service has been correctly configured.
- If connecting using the WAN via ADSL/Cable service, make sure the modem has been enabled,
connected, and is operational, and that the service is correctly configured.
Note: For the product manual, please visit http://support.dlink.com/
4
DWR-922