Page 3
CONTROLS TOP AND FRONT PANELS 1 p - 3.5 mm stereo headphone socket Note: Connecting headphones will switch off the speakers. 2 DIGITAL DYNAMIC BASS BOOST - selects a more vivid bass response 3 ULTRA HIGH CLARITY - adjusts the treble tones 4 INCREDIBLE SURROUND - creates a super-enhanced stereo effect...
Whenever convenient, use the mains supply if you want to conserve battery life. Make sure you remove the mains plug from the set and wall socket before inserting batteries. BATTERIES (NOT INCLUDED) 1. Open the battery compartment and insert 8 batteries, type R-20, UM-1 or D-cells, (preferably alkaline) with the correct polarity as indicated by the "+"...
™ When switching off, if you have been using the CD or tuner function. PHILIPS demo mode 1. On the set, press the CD STOP 9 button for 5 seconds. ™ PH..IL ..IPS and demo mode messages scroll across the display continuously.
GENERAL INFORMATION General maintenance • Do not expose the set, batteries, CDs or cassettes to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight. • To clean the set, use a soft, slightly dampened chamois leather. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.
Page 7
3. Insert a CD with the printed side facing up and press OPEN•CLOSE to close the CD compartment. ™ Display: the CD player scans the contents of a CD, and then the total number of tracks and playing time are shown.
REPEAT button until the various SHUFFLE/ REPEAT modes are no longer displayed. – You can also press STOP 9 to cancel your play mode. Note: In SHUFFLE mode, the display shows rapid patterns e.g. when the CD player selects a random track number. CD PLAYER...
CD PLAYER Programming track numbers In the STOP position, select and store your CD tracks in the desired sequence. If you like, store any track more than once. Up to 20 tracks can be stored in the memory. 1. Use the SEARCH ∞ or § on the set, (for AZ 2025 model only: on the remote control ¡...
CD PLAYER CD player and CD handling • If the CD player cannot read CDs correctly, use a commonly available cleaning CD to clean the lens before taking the set to repair. Other cleaning methods may destroy the lens. • The lens of the CD player should never be touched! •...
– Playing of the CD programme starts automatically from the beginning of the programme. It is not necessary to start the CD player separately. To select and record a particular passage within a track • Press and hold down SEARCH ∞ or § (for AZ 2025 model only: on the remote control ¡...
RECORDING Recording from the radio 1. Tune to the desired radio station (See TUNING TO RADIO STATIONS). 2. Press STOP•OPEN 9/ to open the cassette door. 3. Insert a suitable cassette into the cassette deck and close the cassette door. 4.
TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service centre. WARNING: Do not open the set as there is a risk of electric shock. Under no circumstances should you try to repair the set yourself, as this would invalidate the guarantee.