Hitachi W50 Owner's Manual page 20

AUX IN
You can also listen to music from an external device player by using
the AUX input of this speaker.
Preparation : Connect an external device to the AUX input of the speaker
using a 3.5mm cable (sold separately).
1. Press the INPUT button on the top of the speaker to switch to the AUX
input. The AUX LED will light up GREEN.
2. Start playback on the connected external device.
Note : AUX IN is for connected speaker playback only. Party mode/Grouping
is not supported when connected to the AUX IN.
About Standby
This speaker will automatically enter standby mode with the below
conditions:
a) Wi-Fi Input: The Wi-Fi signal is disconnected or there is no audio
playback for approximately 15 minutes.
b) Bluetooth Input: The Bluetooth source is unpaired or there is no audio
playback for approximately 15 minutes.
c) AUX IN Input: There is no AUX IN cable inserted into the speaker for
approximately 15 minutes.
Note : The AUX IN LED will turn solid RED when the speaker is in standby
mode.
About Wake Up
This speaker will automatically "Wake Up" from the standby mode
when any key on the speaker unit or the "PLAY" icon in the Hitachi Wi-
Fi Speaker app is pressed.
Note : Network configuration and volume settings will be remembered when
the speaker wakes up from standby mode.
20