Siemens optiPoint 410 Administrator's Manual page 75

Description of functions
LAN Port Settings
•
•
•
Æ page 25
Language
•
•
•
Æ page 32
Layer 2 Priority
•
•
•
•
Æ page 22
LDAP Server IP Address
•
•
•
Æ page 27
The PC port settings can be configured only for the optiPoint 410 stand-
ard/advance.
Here you must define the bandwidth at which the optiPoint 410 should
be run. The required value depends on the bandwidth that the switch
or router supports in the network.
Bandwith
10 Mbit/s half dup
10 Mbit/s full dup
100 Mbit/s half dup in 10 Mbit networks with half dup
100 Mbit/s full dup in 100 Mbit networks in full dup
Automatic
1 Up to a date, the data can only be transmitted or received.
2 Up to a date, the data can be simultaneously transmitted and received.
A restart is necessary after the change.
Æ page 58
Can be configured only for the optiPoint 410 standard/advance.
Select the language that should be used for local applications here.
Standard value Æ page 95.
Æ page 57
Can be defined only if the Æ Layer 2 support is activated (Æ QoS L2/
L3).
A priority value between 0 and 7 can be entered for each of the 64
places (priority 7: highly, 0: low).
This additional information decide during communication with a
Æ Switch about the priority forwarding.
Standard value Æ page 95.
Æ page 58
Can be configured only for the optiPoint 410 standard/advance.
If an Æ LDAP server is being used, enter the Æ IP address of this serv-
er here.
IP editor in optiPoint 410 Æ page 94.
Æ page 56
Possible application
in 10 Mbit networks with half dup
in 100 Mbit networks in full dup
in standard case
Alphabetical Reference
1
process
2
process
1
process
2
process
75