Table of Contents
Advertisement
PHILIPS CD-ROM DRIVE USER'S MANUAL
A.2 Setting Master and Slave
Jumpers
Whether your PC system regards your CD-ROM drive as a
master device or a slave device depends on which of
the "
" (master) and "
of the drive is capped.
Slave Mode
Figure A-3 Jumper Settings of Slave Mode and Master Mode
Your CD-ROM drive is shipped with the "
capped,
In spite of this, note from Figure A-3 that
capping the "
" jumper is optional for Slave mode.
To set your CD-ROM drive as a master device, simply
remove the cap from the "
the "
" jumper.
Note: 1. The "MA" and "SL" jumpers cannot be both
capped at the same time.
2. A system halt will occur if the "MA" or "SL"
jumper is set in conflict with the other
device connected to the same IDE port.
IDE port cannot contain two master devices or
two slave devices at any moment of time.
22
24
" (slave) jumpers on the back
or
" jumper and place it over
Master Mode
" jumper
An
A
Advertisement
Table of Contents
