Connecting The Asd - Toshiba G9 ASD Quick Start Manual

Connecting the ASD

Refer to the section titled
Specifications on pg. 16
Power Connections
C o n t a c t W i t h T h e 3 - P h a s e I n p u t / O u t p u t T e r m i n a l s M a y C a u s e
A n E l e c t r i c a l S h o c k R e s u l t i n g I n I n j u r y O r L o s s O f L i f e .
See Figure 20 on pg. 22
An inductor (DCL) may be connected across the PO and PA/+ terminals to provide additional filtering.
When not used, a jumper must be connected across these terminals (see
PA/+ and PB are used for the DBR connection if using a braking resistor.
PC/- is the negative terminal of the DC bus.
R/L1, S/L2, and T/L3 are the 3-phase input supply terminals for the ASD.
U/T1, V/T2, and W/T3 are the output terminals of the ASD that connect to the motor.
The location of the Charge LED for the smaller typeform ASD is provided in
LED is located on the front door of the enclosure of the larger ASDs.
Figure 2. Typical G9 ASD Input/output Terminals and the
Grounding Capacitor Switch — Pull for Small capacitance/push for Large capacitance.
12
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
DANGER
Installation Precautions on pg. 4
before attempting to connect the ASD and the motor to electrical power.
DANGER
for a system I/O connectivity schematic.
and the section titled Lead Length
Figure 20 on pg.
Figure 2. The Charge
Grounding Capacitor
G9 ASD Quick Start Guide
22).
Switch.
Charge LED