Cable/Terminal/Torque Specifications - Toshiba G9 ASD Quick Start Manual

Cable/Terminal/Torque Specifications

Installation should conform to the 2008 National Electrical Code Article 110 (NEC
Installations), all regulations of the Occupational Safety and Health Administration, and any other
applicable national, regional, or industry codes and standards.
Note: The following ratings are guidelines and shall not be the sole determining factor of the
lug or wire size used with the ASD. Application-specific applicables, wire insulation
type, conductor material, and local and regional regulations are but a few of the
considerations when selecting the actual lug and wire type to be used with the ASD.
Note: Cable/Terminal specifications are based on the rated current of the ASD.
The specifications Do Not include the 10% Service Factor.
Note: Use only 75° C copper wire/cable for motor and power connections.
For further installation information see the section titled
Model
MCP Rating
Number
(Amps)
VT130G9U
2010
2015 15
2025
2035
30
2055
2080
50
2110
2160 75
2220 100
2270 125
2330 150
2400 175
2500 200
2600 250
2750 300
210K 400
Note: (*) Indicates that the item is one of a set of two parallel cables.
G9 ASD Quick Start Guide
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
Table 7. 230-Volt G9 ASD Cable/Terminal/Torque Specifications.
Wire/Cable Size
Input/Output Power
Recommended Maximum
14
10
12
10
8 8
4
6
3
4
2 2
1
1/0
4/0
3/0
4/0
*3/0 *4/0
*250 *250
Installation and Connections on pg.
Lug Size Range
AWG or kcmil
Wire-Size/Lug-Capacity for
Input/Output Power
3Ø-Input 3Ø-Output
14 to 8
12 to 8
10 to 4
8 to 3
12 to 1/0 4 to 1/0
6 to 250 2 to 300
6 to 250
) (Requirements for Electrical
10.
Terminal
Board
Torque
TB1 – 4 3Ø- 3Ø-
Terminals Input Output
In-Lbs./Nm
11.5/1.3
17.7/2.0
20
21/2.4
(3-core shield)
5.3/0.6
50/5.7 53/6
275/31 168/19
275/31
75