Cisco 860 Installing Manual page 29

Chapter 2 Installing the Router
Installing on a Table
To install the router on a table or other flat horizontal surface, firmly place the router on a table or other
horizontal surface. Keep at least 1 inch (2.5 centimeters) of clear space for heat dissipation.
Connect the chassis to a reliable earth ground. For the chassis ground connection procedures, see the
"Installing the Router Using the Configurable Low Profile DIN Mount" section on page
Mounting on a Wall
The Cisco 819 ISR has mounting holes on the bottom of the chassis for mounting the unit on a wall or
other vertical surface. The attachment hardware is provided.
When choosing a location for wall-mounting the router, consider cable limitations and wall structure.
Tip
To mount the router on a wall, follow these steps:
Remove the screws on the sides of the routers.
Step 1
Attach the standard brackets to the chassis using the three screws provided for each bracket. (See
Step 2
Figure
Figure 2-25
Install the router to a wall stud using two number-10 wood screws, round- or pan-head, with number-10
Step 3
washers or two number-10 washer-head screws. The screws must be long enough to penetrate at least 1.0
inch (25.4 mm) into the supporting wood or metal wall stud. (See
Note
2-25.)
Attaching the Standard Brackets
The orientation of the Cisco 819 ISR products is critical when wall-mounting. The router must
be oriented as shown in Figure 2-26
the IO side) to comply with IP41 and safety criteria. No other wall mounting orientation is
supported.
with the left side of the router rotated up (as viewed from
Cisco Integrated Services Router Hardware Installation Guide
Installing the Cisco 810 ISR
2-33.
Figure 2-26.)
2-29