Cisco 860 Installing Manual page 4

Installing the Cisco 810 ISR
Figure 2-2
1 6-32 screws
2 Power cable with power cord lock installed
Connect the supplied plenum rated Cat5 cable to the GE0 port on the PoE+ splitter.
Step 3
Connect the Cat5 cable from your PoE+ source to the PoE+ in port on the PoE+ splitter.
Step 4
Place the power cord lock onto the power cord behind the connector overmold as shown in
Step 5
Slide the power cord lock forward so that it captures the overmold and is fully seated.
Figure 2-3
Cisco Integrated Services Router Hardware Installation Guide
2-4
6-32 Screws
Placement of the Power Cord Lock onto the Power Cord
1
1 Power cord connector
2 Power cord lock
Chapter 2
1
2
3
3 To PoE+ power source
4 GE CAT5 cable
2
Installing the Router
4
Figure 2-3.