Jumper Setup - Panasonic EVB-NN30312A User Manual

Regulations 312A805E
No.

2.2 Jumper Setup

EN pin, MODE pin, FSEL pin, PGOOD pin are able to be controlled by J-EN, J-MODE, J-FSEL, J-PGOOD.
Figure 3. Appearance of J-EN, J-MODE, J-FSEL, J-PGOOD
Table 2. J-EN (Control enable/disable）
Jumper
Status
Table 3. J-MODE (Control modes）
Jumper
Mode
Table 4. J-FSEL（Control SW frequency）
Jumper
Frequency
Table 5. J-PGOOD (Control the Voltage PGOOD pin pulled up to）
Jumper
Pull up to
Note: The parameters above is subject to change without notice for improvement.
2012-04-17
Revised
User's Guide
for Evaluation Board
Tentative
J-EN J-EN
enable disable
J-MODE J-MODE
FCCM SKIP
J-FSEL
J-FSEL
250kHz 750kHz
J-PGOOD
J-PGOOD
VREG open
EVB-NN30312A
Total Pages
14
J-EN
disable
J-MODE
SKIP
J-FSEL
1250kHz
J-PGOOD
V-EXT
Industrial Devices Company, Panasonic Corporation
Page
6