Adding Or Editing A Panel; Managing Panels - Sharp PN-Y326 Operation Manual

Adding or editing a panel

n Adding a panel
1. Click .
The add new panel screen appears.
2. Enter the information of the panel to be added.
Panel name*
IP Address
Location*
* A maximum of 32 characters can be set for the panel name and location. Alphanumeric characters, spaces, and symbols
can be used. The following symbols can be used in the panel name and location.
! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ \ ] ^ _ ` { | } ~
• Click "Advanced settings" to set "FTP (Username, Password)", "Telnet (Username, Password)".
The default settings are shown below. Change to match the settings of the panel.
FTP Username:
Telnet Username:
3. Click "OK".
TIPS
• A maximum of 20 panels can be registered.
n Editing a panel
1. Select the panel you want to edit.
2. Click .
The edit panel screen appears.
3. Change the items you want to edit.
4. Click "OK".

Managing panels

n Check the connection status
1. Select the panel you want to check.
2. Click .
Check the network connection status of the registered panel. The result of check connection appears in the result of
connection status area.
OK
ERROR
Set a name that enables easy identification of the panel.
Set the IP address of the panel. You can check the IP address of the panel in the
"INFORMATION" screen.
You can set the location where the panel is installed and comments.
admin FTP Password:
Not set Telnet Password:
The panel is connected normally.
The connection was not confirmed due to a problem.
admin
Not set
9
E