Displaying The Picture - Hitachi CP-WU5500 User Manual

Displaying the picture

1. Activate your signal source. Turn the signal
source on, and make it send the signal to the
projector.
2. Use the VOLUME + / - buttons to adjust the
volume.
3. Press the INPUT button on the projector.
Each time you press the button, the projector
switches its input port in turn.
You can also use the remote control to select an
input signal.
4. Press the ASPECT button on the remote control.
Each time you press the button, the projector
switches the mode for aspect ratio in turn.
5. Use the ZOOM ring to adjust the screen size.
6. Use the FOCUS ring to focus the picture.
7. Turn the VERTICAL adjuster fully counter
clockwise. Then turn it clockwise and adjust the
vertical lens position upward.
Turn the HORIZONTAL adjuster clockwise or
8.
counter clockwise to adjust the horizontal lens
position.
CAUTION
function. Taking any other action may cause the
damage on the projector.
NOTE
The ASPECT button does not work when
no proper signal is inputted.
There may be some noise and/or the screen may
is not a malfunction.
see User's Manual - Operating Guide.
14
VOLUME
MYBUTTON
INPUT
ASPECT PbyP AUTO FREEZE
VOLUME + / -
MAGNIFY FOCUS ZOOM VOLUME
ON
OFF
buttons
PAGE
UP GEOMETRY PICTURE MUTE
DOWN INTERACTIVE NETWORK BLANK
ESC MENU
ENTER
OSD MSG RESET
INPUT button
INPUT
INPUT MYBUTTON
INPUT button
ASPECT PbyP AUTO FREEZE
MAGNIFY FOCUS ZOOM VOLUME
ON
OFF
PAGE
UP GEOMETRY PICTURE MUTE
ASPECT
DOWN INTERACTIVE NETWORK BLANK
ASPECT button
ESC MENU
ENTER
OSD MSG RESET
ZOOM ring
FOCUS ring
VERTICAL adjuster
HORIZONTAL adjuster