Advertisement
before using your Kenwood
appliance
Read these instructions carefully
G
and retain for future reference.
Remove all packaging and any
G
labels.
safety
Watch out for steam, never
G
lift the filter holder lid
during the brewing cycle.
Never touch the hotplate or
G
surrounding area.
Always lift the filter holder
G
lid using the handle at the
front
.
Do not touch hot parts including the
G
cup warming tray/filter holder lid
Never let the cord hang down
G
where a child could grab it.
Never use a damaged appliance.
G
Get it checked or repaired: see
'service and customer care'.
Never put the appliance in water or
G
let the cord or plug get wet - you
could get an electric shock.
Unplug:
G
before filling with water
G G
before cleaning
G G
after use.
G G
Never leave the appliance on
G
unattended.
Do not let the cord touch hot parts.
G
Always make sure there is water in
G
the tank before switching on.
This coffee maker is only suitable
G
for use with the type of carafe
supplied.
Do not leave the appliance
G
switched on with an empty carafe
on the hotplate.
Never put the carafe in the
G
microwave.
Downloaded from CoffeeMachineManual.com Manuals
This appliance is not intended for
G
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
Children should be supervised to
G
ensure that they do not play with
the appliance.
Only use the appliance for its
G
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper
use, or failure to comply with these
instructions.
.
before plugging in
Make sure your electricity supply is
the same as the one shown on the
underside of your appliance.
Important (UK) only
The wires in the cord are coloured
G
as follows:
Green and Yellow = Earth
Blue = Neutral
Brown = Live.
The appliance must be protected
G
by a 13A approved (BS1362) fuse.
WARNING: THIS APPLIANCE
G
MUST BE EARTHED.
Note:
For non-rewireable plugs the fuse
G
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
G
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
3
Advertisement
