Forced Arming; Disarming Areas; Disarming With A Keypad; Disarming With A Master Keypad - Bosch amax 2100 Operation Manual

AMAX panel
P
To enable/disable this function contact your installer.
3.1.3

Forced arming

Arming areas when a zone is not sealed is known as forced
arming.
If the AWAY indicator is not lit and a long beep sounds when you
attempt to arm an area in AWAY mode, then forced arming is not
permitted. In this case, you have to seal all zones or manually
isolate them before you can arm the area.
To enable/disable this function contact your installer.
3.2

Disarming areas

3.2.1

Disarming with a keypad

4
P
3.2.2

Disarming with a master keypad

An optional master text keypad can be added if there is more
than one assigned area on your system.
The master keypad can be used to disarm all assigned areas.
To enable/disable this function contact your installer.
Disarming all areas:
1.
2.
Disarming a single area (direct disarm):
4
P
4
Bosch Sicherheitssysteme GmbH
The STAY indicator flashes slowly and exit time starts. After
the exit time, the STAY indicator is lit.
Enter your code and press [#].
The system beeps twice and the AWAY or STAY indicator is
extinguished.
Enter your code and press [#].
The system beeps twice and the AWAY or STAY indicator is
extinguished. All areas are disarmed.
Enter your code, press the 2-digit area number of the area
to be disarmed and press [#].
The system beeps twice and the AWAY or STAY indicator is
extinguished. The selected area is disarmed.
Repeat if you want to disarm multiple single areas.
Arming and disarming areas | en
2017.04 | 07 | F.01U.295.569
23