Tips And Safety Instructions - Hitachi FHD7510PC Operation Manual

TIPS AND SAFETY INSTRUCTIONS

Warning : The socket outlet shall be installed near
the equipment and shall be easily accessible.
- The TFT colour LCD panel used in this monitor is
made with the application of high precision
technology. However, there may be minute points
on the screen where pixels never light or are
permanently lit. Also, if the screen is viewed from
an acute angle there may be uneven colours or
brightness. Please note that these are not
malfunctions but common phenomena of LCDs and
will not affect the performance of the interactive
monitor.
- Do not display a still picture for a long period, as
this could cause a residual image.
- Never rub or tap the monitor with hard objects.
- Please understand that manufacturer bears no
responsibility for errors made during use by the
customer or a third party, nor for any other
malfunctions or damage to this interactive monitor
arising during use, except where indemnity liability
is recognized under law.
- This interactive monitor and its accessories may be
upgraded without advance notice.
- Do not use the interactive monitor where there is
a lot of dust, where humidity is high, or where the
interactive monitor may come into contact with oil
or steam. Do not use in an environment where
there are corrosive gases (sulfur dioxide, hydrogen
sulfide, nitrogen dioxide, chlorine, ammonia, ozone,
etc.) as this could lead to fire.
- Ensure that the interactive monitor does not come
into contact with water or other fluids. Ensure that
no objects such as paper clips or pins enter the
interactive monitor as this could lead to fire or
electric shock.
- Do not place the interactive monitor on top of
unstable objects or in unsafe places. Do not allow
the interactive monitor to receive strong shocks or
to strongly vibrate. Causing the interactive monitor
to fall or topple over may damage it.
- Do not use the interactive monitor near heating
equipment or in places where there is likelihood of
high temperature, as this may lead to generation of
excessive heat and outbreak of fire.
- Do not use the interactive monitor in places where
it may be exposed to direct sunlight.
- Please be sure to constantly remove dust that has
attached to the ventilation opening. If dust collects in
the ventilation opening or the inside of the
interactive monitor, it may lead to excessive heat,
outbreak of fire, or malfunction. Please request a
cleaning of the inside of the interactive monitor from
an authorized servicing dealer or service center.
The Power Cord
- Use only the power cord supplied with the
interactive monitor.
- Do not damage the power cord nor place heavy
objects on it, stretch it or over bend it. Also, do not
add extension cords. Damage to the cord may result
in fire or electric shock.
- Adding an extension cord may lead to fire as a
result of overheating.
- Do not remove or insert the power plug with wet
hands. Doing so could result in electric shock.
- Unplug the power cord if it is not used for a long
time.
- Do not attempt to repair the power cord if it is
broken or malfunctioning. Refer the servicing to the
service representative.
Manual Scope
- Language of OSD menu used in this manual is
English by way of example.
- This manual assumes use in landscape orientation,
except where specifically noted.
- Illustrations in this manual may not exactly
represent the actual interactive monitor or display.
• Such as keypad, vent holes and speakers' position
may be in a different place from illustrations.
• Dimensional Drawing (page: 27) exactly
represents your interactive monitor specifications.
LED Backlight
- The LED backlight in this interactive monitor has a
limited lifetime.
- If the screen gets dark or does not turn on, it may
be necessary to replace the LED backlight.
- This LED backlight is exclusive to this interactive
monitor and must be replaced by an authorized
servicing dealer or service center. Please contact an
authorized servicing dealer or service center for
assistance.
8