Network And General Settings - Bosch dicentis Configuration Manual

22 en | Web browser interface
5.
6.
7.
5.4.7

Network and general settings

Click the Network and general settings button to open the network and general settings
page. Here the network and general settings are displayed and can be set:
Click the Change network settings button to enter/change the network settings:
–
–
–
–
Setting up a redundant WAP
This procedure describes how to set up a redundant WAP for wireless operation/redundancy.
2016.07 | V2.0 |
– A file will be generated. Save it to a USB memory stick.
Go to the license page of the web browser interface application.
Click the Process response message button.
– Select the correct file from the USB memory stick, and then click "open".
– A save as dialog is shown. Save the file to your USB memory stick.
Return to the license website, go to "manage license", and upload the "request file" from
the USB memory stick.
– Now the license is returned.
Network settings:
– Hostname: Enter the network name of the DCNM‑WAP. The default name is
dcnm‑wap.
Wifi
– Network name (SSID): Bosch DICENTIS (factory default).
– WPA2 Key (password): dcnm-wap (factory default).
– Channel: Shows the currently selected WiFi channel. The channels are selected in
the Carrier Management page. See Carrier Management, page 26.
Wired:
– Fixed IP: Select this checkbox if you want to use a fixed IP address. The fields below
change from grey to white to indicate that they are activated.
– IP address: Enter a valid IP address.
– Subnet mask: Enter a valid subnet mask.
– Default gateway: Enter a valid default gateway.
WAP redundancy: Use these settings to configure the WAP as a standalone, primary or
secondary Wireless Access Point. The Primary and Secondary buttons are used to set up
a redundant system.
– Standalone (factory default setting): The connected WAP functions as a single
Wireless Access Point. No redundant WAP is configured.
– Primary: Selects the connected WAP as the primary Wireless Access Point. To do
this, select Primary. As soon as the WAP is set to primary, the Subscription mode
check box is enabled. This check box is used to enable subscription of a secondary
WAP.
– Secondary: Selects the connected WAP as the secondary Wireless Access Point. To
do this, select Secondary. As soon as the WAP is set to secondary, the Subscribe
button is enabled after login. This button is used to subscribe the secondary WAP to
the primary WAP.
– Subscription mode check box: Use this checkbox on the primary WAP in
combination with the Subscribe button on the secondary WAP to subscribe a
secondary WAP to the primary WAP. If the Subscribe button is not selected within
two minutes, the check mark will disappear and will have to be selected again.
– Subscribe: Use this button on the secondary WAP in combination with the
subscription mode on the primary WAP to subscribe the WAP as the secondary
Wireless Access Point. The configured and operation status of the WAPs is displayed
below the Subscribe button.
Configuration manual
DICENTIS
Bosch Security Systems B.V.