3
Parameters operating area
3.5 Settable zero offset
3.5.3 Rotation/Scale/Mirroring (ZO)
3-40
Function
Rotation, scale and mirroring can be entered or modified for each of
the three coordinate axes.
Precondition
• The softkey Rot./Scale has been pressed in the ZO – Offset
working window.
The following working window is then displayed:
Working window: Settable ZO – Rotation/Scale/Mirroring
Operating sequence
• Select the input field with the cursor.
• Change the angle of rotation or the scale numerically.
• Press Input to jump to the next input field.
• Switch the mirroring on or off using the Select key.
• Click on the Save softkey to accept the entries.
Further buttons
ZO -/+
Previous/next ZO
Offset
Use this softkey to access the Offset working
window.
Refer to Chapter: Offset (ZO)
Cancel
Discards the entry.
Recall
Returns to the Settable ZO Overview operating
window
SINUMERIK 840D/840Di/810D Operator's Guide Handheld Terminal 6 (BAH) - 03.04 Edition
3
03.04
Siemens AG, 2004. All rights reserved.