Key Features
Key Features
Inline Power
Note
Caution
Caution
Cisco Aironet Access Point Hardware Installation Guide
1-2
This section describes the key features of the Access Point:
•
Inline power
Omni-directional antennas
•
•
Ethernet and serial ports
Indicator lights
•
Cisco Aironet 350 series Access Points receive power through the Ethernet cable,
so you don't need to run a separate power cord to the Access Point. Plug the
Ethernet cable into the Ethernet port on the back of the Access Point and plug the
other end into one of three possible power sources:
•
A Cisco Aironet power injector
A switch with inline power, such as the Cisco Catalyst 3524-PWR-XL switch
•
•
A power patch panel, such as the Cisco Catalyst Inline Power Patch Panel
Cisco Aironet 340 series Access Points rely on a separate power
supply plugged into the power port on the back of the Access Point.
Cisco Aironet power injectors are designed for use with 350 series
Access Points and bridges only. Using the power injector with other
Ethernet-ready devices can damage the equipment.
The operational voltage range for Cisco Aironet 350 Series Access
Points and Bridges is 24 to 60 VDC. Higher voltage can damage the
equipment.
Chapter 1
Overview
OL-0738-01