Cisco Aironet 340 Series Hardware Installation Manual page 38

Connecting the Ethernet and Power Cables
The operational voltage range for Cisco Aironet 350 Series Access
Caution
Points and Bridges is 24 to 60 VDC. Higher voltage can damage the
equipment.
Connect the other end of the Ethernet cable to the device that will supply power.
Step 3
If you use a power injector, follow these additional steps:
a.
b.
c.
d.
At start-up, all three LEDs on the top of the Access Point slowly blink amber, red,
and green in sequence; the sequence takes a few minutes to complete. During
normal operation, the LEDs blink green. Refer to Chapter 4, "Troubleshooting,"
for LED descriptions.
Step 4 Follow the steps in Chapter 3, "Basic Configuration," to assign basic settings to
the Access Point.
Cisco Aironet Access Point Hardware Installation Guide
2-12
Plug the cable from the Access Point into the end of the power injector
labeled To AP/Bridge.
Run an Ethernet cable from the end of the power injector labeled To Network
to the 10/100 Ethernet switch.
Plug the female end of the power cord into the universal power supply.
Plug the male end of the power cord into a power outlet or power strip.
Chapter 2 Installation
OL-0738-01