Philips **HFL5011T/12 Installation Manual page 42

 Navigate to the [Manage] menu
 When opening this menu you will be able
to manage the sources
 You should get the same menu as Manage
channels as this is the same channel list
except that the highlight is on the first
source
 See chapter 'Manage Channels' for more
details
 Navigate to the [Advanced] menu
 You will see below items:
o [Enable Sources]: You can Hide/Show
sources
o [AutoSCART]:
 [Off]: TV shall not react to any
SCART pin8 break-in event, both in
power on state and power standby
state
 [On]: TV shall react to SCART pin8
break-in event and switch to the
SCART extension where the break-
in event occurs. This shall also be
applicable when TV is powering up
either from power standby mode or
mains power on
 [Power on SCART]: TV shall enable
the power on SCART function, the
power state of the TV will depend
on the state of pin8. When pin 8 is
low the TV will go to standby, when
high the TV will go to ON state
o [Easylink]:
 [EasyLink]: Disable all HDMI CEC
functionalities via [Off] or enable
via [On]
 [EasyLink Break-in]: TV shall disable
auto
connected HDMI CEC enabled
source via [Off] or enable via [On]
when device is plugged or switched
on
 [EasyLink Remote Control]: The
keys from your TV RC will not be
forwarded via CEC via [Off] or will
be forwarded via [On]
Note: Above menus are only
accessible when [EasyLink] is set to
[On]
- 41 -
tuning/switching to the