Table of Contents
Advertisement
e DSPLY [display] button
Press to light this button, in order that the source name /
bus name displays show the signal names or bus names
corresponding to the current bus delegation.
Transition Control Block (Standard Type)
In the transition control block, you can modify the output
of the M/E bank or PGM/PST bank, and perform
9 PRIOR SET button
1 Next transition selection buttons
3 Transition execution section
4 Wipe direction selection buttons
a Next transition selection buttons
Press these buttons, turning them on, to determine what the
next transition will apply to.
8 Key status display
2 Transition type selection buttons
6 Pattern limit buttons
5 TRANS PVW button
f DEST button
When both the [DSPLY] button and this button are on, the
key bus names or AUX bus names are displayed.
g KEY button
When you press a cross-point button while holding down
this button, the key signal is selected.
transitions. Both common transition and independent key
transition operations are possible.
q; Key delegation buttons
qd Key source name display/key
snapshot buttons
qs Independent key transition execution section
qa Independent key transition type selection buttons
7 KF button
Names and Functions of Parts of the Control Panel
qf Key
snapshot
setting
buttons
37
Advertisement
Table of Contents
