Applying Power and Verifying the Installation
Completing Initial System Configuration
After power is applied to the chassis and the ASR 5000 has successfully booted, the command line interface (CLI)
appears on a terminal connected to the Console port of the SPIO.
The initial configuration requires completing the following tasks via the CLI:
Configuring the system for remote access
Configuring the management interface with a second IP Address (optional)
Configuring system timing
Enabling CLI timestamping
Configuring system administrative users
Configuring TACACS+ for system administrative users (optional)
Configuring a chassis key
Configuring virtual MAC addresses
Configuring packet processing and line card availability
Configuring line card and SPIO port redundancy
Configuring ASR 5000 link aggregation (optional)
Configuring ORBEM and the Web Element Manager (optional)
Configuring SNMP support and trap generation
The Getting Started, Configuring System Settings and Configuring Management Settings chapters of the System
Administration Guide provide detailed procedures for completing the above tasks.
Completing Initial System Configuration ▀
ASR 5000 Installation Guide ▄
185