3.2
CD mechanism assembly
3.2.1 Removing the Mecha control board
(1) Solder the short land on the pickup. (See Fig. 1)
(2) Remove the eight wires from the Mecha control board.
(See Fig.2)
(3) Disconnect the flexible wire from the pickup connected to
the connector
CN102
Fig.3)
(4) Remove the two screws A attaching the Mecha control
board. (See Fig.3)
SOLDER
Fig.1
BLACK
RED
WHITE
YELLOW
ORANGE
ORANGE
WHITE
YELLOW
Fig.2
on the Mecha control board. (See
A
CN102
Fig.3
(No.WA002<Rev.001>)9/20
3.2.2 Removing the Traverse mechanism (See Fig.4, 5)
(1) Remove the five springs from the traverse mechanism.
(See Fig.4)
(2) Remove the three screws B attaching the bottom frame as-
sembly. (See Fig.5)
(3) Remove the three dumpers from the bottom frame assem-
bly. (See Fig.5)
B
3.2.3 Removing the Pickup (See Fig.6, 7)
(1) Remove the two screws C attaching the feed bracket as-
sembly. (See Fig.6)
C
Fig.4
B
Fig.5
C
Fig.6