Toshiba ABX3250KN User Manual page 16

Audio base speaker system
Table of Contents

Advertisement

16
Subwoofer wireless connection
In order to use the subwoofer, you must pair it with the Audio Base.
1. Connect the power cord to a wall outlet.
2. Turn on the Audio Base.
3. Turn the ON/OFF switch on the back of subwoofer to the "on" position.
4. The Audio Base and the subwoofer will automatically pair up. The pairing indicator located in
upper right corner of the rear panel will appear red when the wireless link is activated.
When the wireless link is deactivated, the Audio Base will show "NO
SUBWOOFER" on the front panel display. You can press and hold the
button on the remote control for 8 seconds in HDMI
and hold the WIRELESS LINK button of the subwoofer for approximately 5
seconds until the red indicator flashes.
The Audio Base will show "PAIRED" when the Audio Base and the subwoofer
link are active.
®
Bluetooth
connection by NFC
NFC (Near Field Communication) is a technology enabling short-range wireless communication
between various devices, such as mobile phones and IC tags.
By just touching the Audio Base where the "N-mark" is located with an NFC compatible device,
the Audio Base is turned on automatically and then paired and connected with the various devices,
such as mobile phones. To locate the "N-mark" on the unit, please see "NFC (N-Mark)" on page 7.
1. Start and turn on the NFC function on the device. Keep touching the device on the "N-Mark"
of the Audio Base until the device vibrates or a message pops up; the Bluetooth
automatically.
2. Touch the device to the Audio Base again to disconnect. In order to avoid unintentional
disconnection, it is advised that you place your device away from the "N-mark" once connected.
The NFC function is built into devices for Android™ 4.1 Jellybean or later.
If your device is powered by a previous version than Android™ 4.1 Jellybean,
you must download the relevant application from the Google Play
use the NFC function.
The position of the NFC antenna differs on devices. Check the NFC antenna
location before connecting. If your device is covered with a thick case, the
connection may not succeed.
For details, please refer to the user's manual of your NFC device.
ABX3250KN_IB_28-02-2014_L.indd 16
®
-2 mode. And then, press
®
will be paired
store to
TM
2014/2/28 17:08:49

Advertisement

Table of Contents
loading

Table of Contents