Replacing The Rotor - Toro 1500 Power Curve 38371 Operator's Manual

1. Screw (2)
1. Screws
2. Remove and discard the old scraper.
3. Install the new scraper, and fasten it securely with the 4
screws that you previously removed.

Replacing the Rotor

1. Remove the screws that secure the right side plate to the
appliance frame (Figure 10).
2. Remove the rotor pin (Figure 11).
Figure 8
Figure 9
Figure 10
1. Rotor pin
3. Remove the old rotor.
4. Install the new rotor by inserting the end of the rotor onto the
fitted end in the housing and rotating the rotor until it snaps
into place (Figure 12).
1. Fitted end of the rotor
Note: Ensure that the nut that secures the rotor pin remains
inside the recessed hole in the right inside wall of the
housing.
Note: The housing will flex when you install the rotor.
5. Tighten the bolt on the side of the housing.
6. Install the right side plate with the screws that you removed
in step 1.
7
Figure 11
Figure 12