1. Scraper
1. Remove the screw from each side plate that holds the
scraper
(Figure
8) and 2 screws from under the appliance
(Figure
9) that secure the scraper to the appliance.
1. Screw (2)
1. Screws
2. Remove and discard the old scraper.
3. Install the new scraper, and fasten it securely with the 4
screws that you previously removed.
Replacing the Rotor
1. Remove the screws that secure the right side plate to the
appliance frame
(Figure
Figure 7
Figure 8
Figure 9
10).
2. Remove the rotor pin
1. Rotor pin
3. Remove the old rotor.
4. Install the new rotor by inserting the end of the rotor onto the
fitted end in the housing and rotating the rotor until it snaps
into place
(Figure
12).
1. Fitted end of the rotor
7
Figure 10
(Figure
11).
Figure 11
Figure 12