Setup
Note: Determine the left and right sides of the appliance
from the normal operating position.
Installing the Upper Handle
1. Remove the handle knobs, oval bolts, and curved washers
from the lower handle.
2. Install the upper handle to the lower handle of the appliance
with the handle knobs, curved washers, and oval bolts as
shown in
Figure
1.
1. Handle knob (2)
2. Curved washer (2)
3. Oval bolt (2)
Note: Ensure that the power cord attached to the
appliance is routed over the lower handle and to the
inside of the handle assembly.
3. Tighten the handle knobs firmly by hand.
4. Attach the cord guide to the handle
Figure 1
4. Lower handle
5. Upper handle
(Figure
2).
1. Cord guide
2. Handle
Operation
Product Overview
1. Rotor blades
2. Belt cover (not shown)
3. Chute deflector
4. Chute-deflector trigger
5. Discharge-chute handle
6. Cord guide
Important: This appliance is intended for outdoor,
residential use only. Do not use it indoors or for
commercial or industrial purposes.
4
Figure 2
3. Cord
Figure 3
7. Interlock button
8. Power-control bar
9. Upper handle
10. Cord
11. Handle knobs
12. Discharge chute