Sharp DW-71-H Service Manual page 13

3. Removing the main unit front part
(1) Remove the casing SK fixing screws (2 pcs.).
(Handle reinforcement angle fixing screws)
(2) Widen outward the lower parts of main unit front
part, and withdraw to this side.
(3) Remove the power supply cover inside the evaporator
top box.
Transfomer cover (The transformer is under the cover)
Screw
Earth terminal
(4) Holding the power supply PWB, withdraw the harness
of operation section.
Display PWB harness
Screw
Casing
Screw
Power supply cover
Power supply PWB
Main parts
Power supply PWB
Magnetic coil
Dryer
Filter
Suction pipe ass'y
Butyl rubber
Bottom plate
ass'y
Sirocco fan
Capacitor
FULL switch
4. Removing the fan motor
(If the fan motor failed to run, be sure to replace the fan
together with the fan motor.)
(The fan vibrates more remarkably, causing growing
noise.)
After removing the front and rear parts of main unit
(1) Disconnect the connector of power supply PWB.
(2) Release the harness from the casing.
(3) Remove the screws fixing the casing to the main unit.
Casing
Fan fixing
screw
13
DW-71-H
Evaporator top box
Evaporator
Fin cover
Dew pan
Fan motor
Casing
Compressor
For fan motor
Harness
fixing rib
Screw