Mitsubishi Electric AG-150A Instruction Book page 36

(3)Set the contents of the schedule setting
When one of the [Edit] buttons in the Contents of Schedule box is
clicked, a screen to set a schedule operation will appear. Use this
screen to set when to run an operation and set the type of schedule
operation (ON/OFF, operation mode, temperature setting,fan
direction, fan speed, prohibit remote controller operation) and then
press the [OK] button.
It is possible to schedule operation by specifying the settings for
selected items (e.g., operation mode only or preset temperature only).
Note: When [Optimized start] is selected, the unit starts 5 - 60 minutes before the scheduled time based on the
operation data history in order to reach the scheduled temperature at the scheduled time. (When the unit
starts the first time after power reset, the operation starts 30 minutes before the scheduled time.) When using
this function, also set the operation mode and setting temperature. If "Prohibit Remote Controller" is set at the
same time, remote controller is prohibited at its setting time.
If the room temperature is measured by the air-conditioner's suction temperature sensor, the temperature
may not be correct when the air-conditioner is inactive and the air is not fresh. When the temperature is not
measured correctly, switch the sensor to external temperature sensor (PAC-SE40TSA) or remote control
sensor.
Note: Only air conditioner units can set [Optimized start].
Note: The CITY MULTI model supports a temperature setting range of 12-28°C / 53-83°F when in Heat mode.
(When S series (PUMY) is used, set the temperature at 17°C-28°C / 63-83°F in heat mode.)
Note: When setting a schedule for all groups or for a block, it is possible to set all operation modes such as Auto
mode etc, but if some targeted air conditioner units do not have such a function, then those units will not run in
the specified mode. When setting the schedule, consider what functions are supported by the air conditioner
units.
Note: When setting a schedule for all groups or for a block, it is possible to set prohibit remote controller items
individually. When allowing remote controller operation under K control, however, all items must be set
enable.
Note: When setting a schedule for ventilator units, the temperature setting and fan direction setting are not
displayed. Moreover, the prohibit remote controller operation is simply [ON/OFF].
Note: When setting a schedule for Air To Water (PWFY) units, the fan direction setting and fan speed setting is are
not displayed.
Note: Only the ON/OFF operation is possible on the general equipment.
(4)Specify the day(s) for pattern allocation
Allocate the set schedule pattern for days such as public holidays or
summer vacation that has scheduling requirements different to the
weekly schedule.
To allocate a schedule pattern to a day, first click the pattern you wish
to allocate to select it and then select the day in the calendar by
clicking on the rectangle corresponding to the day. When selected, the
day will display the number of the pattern that has been allocated.
If you wish to remove a pattern allocation from a day, select [Pattern Cancel] and then click on that day's
rectangle.
(5)Copy a schedule to another pattern or to another group
When copying a schedule between each pattern, click [Copy (Pattern)]
button. The color of the button turns to green (which means the button
is selected). Select the desired pattern, and click [Paste] button.
When copying all patterns of schedules or an allocated day of the
pattern between each group, click [Copy (Group)] button. Select the
desired group, and click [Paste] button.
Note: Copied schedule cannot be pasted to different type of
equipment. For example, schedule copied on the air conditioner
cannot be pasted to the ventilator equipment.
Note: The operation mode that can be pasted and the temperature
setting range vary depending on the unit type.
36
OK Button
Copy (Pattern) / Paste
Copy (Group) / Paste