Cleaning The Water Tank; Cleaning The Inside Of The Coffee Maker; Cleaning The Brewing Unit; Cleaning The Milk Container - AEG KKK884500 User Manual

Cleaning the inside of the coffee maker

1. Check regularly (about once a week) that the inside of the
appliance is not dirty.
If necessary, remove coffee deposits with the brush (C8)
supplied and a sponge.
2. Remove the residues with a vacuum cleaner (fig. 30).

Cleaning the brewing unit

The brewing unit must be cleaned at least once a month.
Important! The brewing unit (A5) must not be re-
moved when the appliance is on.
Do not use force to remove the brewing unit.
1. Make sure the machine is correctly turned off (see "Turning
the appliance off").
2. Open the service door (fig. 26).
3. Remove the drip tray and waste coffee container (fig. 27);
4. Press the two red release buttons inwards and at the same
time pull the brewing unit outwards (fig. 31).
Important! Do not use washing up liquid to clean the
brewing unit. It would remove the lubricant applied to the inside
of the piston.
5. Soak the brewing unit in water for about 5 minutes, then
rinse.
Use the brush (C8) to remove any coffee residues left in the
unit.
6. After cleaning, replace the brewing unit (A5) by sliding it
onto the internal support and pin at the bottom, then push
the PUSH symbol fully in until it clicks into place.
Support
Pin
N.B.: If the brewing unit is difficult to insert, you must
first adapt it to the right dimensions by pressing it forcefully
from the bottom and top as shown in the figure.
7. Once inserted, make sure the two red buttons have snapped
out.
8. Replace the drip tray and waste coffee container.
9. Close the service door.

Cleaning the milk container

Important! Always clean the tubes inside the milk
container (C) when you prepare milk.
If there is still milk in the container, do not leave it out of the
refrigerator for longer than strictly necessary.
Clean the container each time you prepare milk as described in
Note 3 in the section "Making cappuccino".
All components can be washed in a dishwasher, placing them in
the top basket of the dishwasher.
1. Turn the lid of the milk container clockwise then remove it.
2. Remove the milk spout and intake tube.
spout
milk intake tube
Frothed milk regulator
13
EN
Groove