GE UR Series B30 Instruction Manual page 167

5 SETTINGS
Table 5–2: OSCILLOGRAPHY CYCLES/RECORD EXAMPLE
RECORDS CT/VTS
1 1
1 1
8 1
8 1
8 2
8 2
8 2
8 2
32 2
A new record may automatically overwrite an older record if
Set the to a percentage of the total buffer size (for example, 10%, 50%, 75%, etc.). A trigger position of
TRIGGER POSITION
25% consists of 25% pre- and 75% post-trigger data. The
any FlexLogic™ parameter (element state, contact input, virtual output, etc.). The relay sampling rate is 64 samples per
cycle.
The setting determines the sampling rate at which AC input signals (that is, current and voltage) are
AC INPUT WAVEFORMS
stored. Reducing the sampling rate allows longer records to be stored. This setting has no effect on the internal sampling
rate of the relay which is always 64 samples per cycle; that is, it has no effect on the fundamental calculations of the device.
When changes are made to the oscillography settings, all existing oscillography records will be CLEARED.
NOTE
b) DIGITAL CHANNELS

PATH: SETTINGS PRODUCT SETUP
 DIGITAL CHANNELS

MESSAGE
MESSAGE
MESSAGE
A setting selects the FlexLogic™ operand state recorded in an oscillography trace. The length of
DIGITAL 1(63) CHANNEL
each oscillography trace depends in part on the number of parameters selected here. Parameters set to "Off" are ignored.
Upon startup, the relay will automatically prepare the parameter list.
GE Multilin
SAMPLE DIGITALS
RATE
8 0
16 16
16 16
16 16
16 16
16 63
32 63
64 63
64 63
TRIGGER MODE
TRIGGER SOURCE
 
OSCILLOGRAPHY
DIGITAL CHANNEL
Off
DIGITAL CHANNEL
Off
DIGITAL CHANNEL
Off
↓
DIGITAL CHANNEL 63:
Off
B30 Bus Differential System
ANALOGS CYCLES/
RECORD
0 1872.0
0 1685.0
0 276.0
4 219.5
4 93.5
16 93.5
16 57.6
16 32.3
16 9.5
is set to "Automatic Overwrite".
is always captured in oscillography and may be
DIGITAL CHANNELS
Range: FlexLogic™ operand
1:
Range: FlexLogic™ operand
2:
Range: FlexLogic™ operand
3:
Range: FlexLogic™ operand
5.2 PRODUCT SETUP
5
5-43