Additional Information; Precautions - Sony TA-DK2 Operating Instructions Manual

Categories and the
corresponding buttons
Categories
VCR (command mode VTR 3)
VCR (command mode VTR 2)
DVD player/DVD recorder
(command mode DVD1)
DVD recorder
(command mode DVD3)
CD player
MD deck
Tape deck B
DVR (Digital CATV terminal)
DSS (Digital Satellite Receiver)
a)
Sony VCRs are operated with a VTR 2 or VTR 3
setting which correspond to 8 mm and VHS
respectively.
b)
Sony DVD recorders are operated with a DVD1 or
DVD3 setting. For details, refer to the operating
instructions supplied with the DVD recorders.
To clear all remote button
assignments
Press ?/1, SLEEP and MASTER VOL – at the
same time.
The remote is reset to its factory settings.
30
GB
Press
a)
1
a)
2
3
b)
4
b)
5
6
7
8
9

Additional Information

Precautions

On safety
Should any solid object or liquid fall into the
cabinet, unplug the amplifier and have it
checked by qualified personnel before
operating it any further.
On power sources
• Before operating the amplifier, check that
the operating voltage is identical with your
local power supply.
The operating voltage is indicated on the
nameplate on the back of the amplifier.
• The unit is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, even if the unit
itself has been turned off.
• If you are not going to use the amplifier for
a long time, be sure to disconnect the
amplifier from the wall outlet. To disconnect
the AC power cord, grasp the plug itself;
never pull the cord.
• The AC power cord must be changed only at
a qualified service shop.
On heat buildup
Although the amplifier heats up during
operation, this is not a malfunction. If you
continuously use this amplifier at a large
volume, the cabinet temperature of the top,
side and bottom rises considerably. To avoid
burning yourself, do not touch the cabinet.