Remote Control - Sony TA-DK2 Operating Instructions Manual

There is no sound from one of the front
speakers.
• Check that all the cords are fully inserted
into the jacks on both the amplifier and the
component. Check the connection of the
front speaker which is not outputting any
sound.
• Make sure you have connected to both the
L and R jacks of an analog component, and
not only to either the L or R jack. Use an
audio cord (not supplied).
The left and right sounds are
unbalanced or reversed.
• Check that the speakers and components
are connected correctly and securely.
• Adjust the balance parameters (page 21).
There is severe hum or noise.
• Check that the speakers and components
are connected securely.
• Check that the connecting cords are away
from a transformer or motor, and at least
3 m away from a TV set or fluorescent
light.
• Move your audio components away from
the TV.
• The plugs and jacks are dirty. Wipe them
with a cloth slightly moistened with
alcohol.

Remote control

The remote does not function.
• Point the remote at the remote sensor on
the amplifier.
• Remove any obstacles in the path between
the remote and the amplifier.
• Replace all the batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on
the remote.
32
GB
Error message
If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. Refer to the following
table to solve the problem. If any problem
persists, consult your nearest Sony dealer.
PROTECT
Irregular current is output from the
speakers. The amplifier will automatically
turn off after a few seconds. Check the
speaker connection and turn on the power
again.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the amplifier's memory may remedy
the problem (page 16). However, note that all
memorized settings will be reset to their
factory settings and you will have to readjust
all settings on the amplifier.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the amplifier's memory
To clear
All memorized settings
See
page 16