Brother HL-1110 Service Manual page 70

Assembling Note:
• Fold the laser unit flat cable as shown in the figure below.
Electrode plane
To be connected
to laser unit
Mountain fold
Valley fold
Assembling Note:
• If you replaced the laser unit, attach the serial number label of the laser unit onto the
location shown in the figure below.
• After the assembly, refer to
enter the adjusted value of the laser unit.
Serial number label
45° 45°
Fig. 2-21
"2. IF YOU REPLACE THE LASER UNIT" in chapter 3
Fig. 2-22
2-23
Laser unit flat cable
45°
155 mm
172 mm
Electrode plane
To be connected to
main PCB ASSY
20 mm
to
Confidential