Siemens SINUMERIK 840D sl Operating Manual page 156

Multi-channel view
6.2 Multi-channel view in the "Machine" operating area
● The same window is displayed for both channels in the lower window.
● You can select the display in the lower window using the vertical softkey bar.
Single channel view
If, for your multi-channel machine, you always only wish to monitor one channel, then you
can set a permanent single-channel view.
Horizontal softkeys
● Block search
● Program control
● If you press an additional horizontal softkey in the "Machine" operating area (e.g.
Switching between single and multi-channel view
Editing a program in the block display
You can perform simple editing operations as usual in the actual block display.
If there is not sufficient space, you switch over into the single-channel view.
Running-in a program
You select individual channels to run-in the program at the machine.
156
The following exceptions apply when making a selection using the vertical softkeys:
– The "Actual values Machine" softkey switches over the coordinate systems of both
channels.
– The "Zoom actual value" and "All G functions" softkeys switch into the single-channel
view.
When selecting the block search, the multi-channel view is kept. The block display is
displayed as search window.
The "Program control" window is displayed for the channels configured in the multi-
channel view. The data entered here apply for these channels together.
"Overstore", "Synchronized actions"), then you change into a temporary single-channel
view. If you close the window again, then you return to the multi-channel view.
Press the <MACHINE> key in order to briefly switch between the single
and multi-channel display in the machine area.
Press the <NEXT WINDOW> key in order to switch between the upper
and lower window within a channel column.
Operating Manual, 02/2011, 6FC5398-6AP40-0BA0
Universal