Configuring The Recording Disk Settings - Sony HAW-EIBU Installation Manual

• [Recording]: Install only the recording server onto
the unit. Select this when configuring a system with
multiple Network Video Recorders.
If you selected [All-In-One], proceed to the
"Installation in all-in-one mode" section. If you
selected [Recording], proceed to the "Installation in
recording mode" section.
Installation in all-in-one mode
1
Copy the license file acquired in the "Registering the
Software License Code (SLC) and Acquiring the
License File" procedure to a USB flash memory
device.
2
Connect the USB flash memory device to the unit.
3
Click [Browse...].
4
Select the software license file stored on the USB
flash memory device, and click [Open].
5
Click [Next].
6
Click [Next] again.
7
Click [Finish].
Installation in recording mode
1
Enter the IP address, user name, and password for the
management server, and click [Next].
Notes
• Configure the user name as follows.
<IP address of the computer on which the
management server is installed>\<user name>
• If an error message appears, check that the time
settings on the management server and the unit are
the same.
2
Click [Setup].
The recording server installation dialog box appears.
3
Select the language to use for the installer, and click
[Continue].
4
Click [Typical].
5
Enter the recording server name and management
server's IP address, and click [Continue].
Note
The path specified in [Media database] will be
changed to the path for the RAID drive after the
RAID settings are configured, so leave the default
path unchanged for now.
6
Select the language to use for the Network Video
Recorders under [Product language], and click
[Install].
Caution
Do not change the file location. Changing this setting
may result in unstable operation.
7
Click [Close].
Installation of the recording server will complete.
8
Click [Finish].
Setup Wizard closes.
Configuring the Recording Disk
Settings
Configure a recording disk for the internal HDDs to be
used as the storage destination for recorded video,
archives, and exported data. To configure the recording
disk, start by creating a disk array using RAID
22