Panasonic SC-AP01 Owner's Manual page 6

SC-AP01PPC~RQT9655.book 6 ページ ２０１２年２月２日 木曜日 午後１０時４２分
Method 1
If your wireless network router supports WPS*
∫ Using the WPS Push Button Configuration
(PBC)
WPS Push Button
Configuration (PBC)
compatible wireless router may
have this mark.
1
Press and hold [– WPS] on the unit for
more than 2 seconds.
The Wi-Fi status indicator blinks blue. Continue to
{.
®
step 2.
≥ Complete step 2 within 2 mins.
2
Press the WPS button on the wireless
router.
{. When a link is established
blinks quickly.
{. When the configuration is finished,
indicator lights blue.
≥ This unit can also be set using the WPS PIN code.
Replace step 2 of "Method 1" with the following steps.
(Before starting, refer to the wireless network router's
operating instructions for details on how to enter the PIN
code.)
1 While the Wi-Fi status indicator blinks blue, press
®
and hold [– WPS] again.
The Wi-Fi status indicator blinks purple.
{. ®
Continue to the next step.
2 Enter the PIN code "64428147" into the wireless
router.
≥ To edit this system's name it is necessary to use
"Method 2".
≥ The Wi-Fi status indicator turns off or blinks red if the
®
connection was not made within the set time limit. Try
the setting again. If the Wi-Fi
off or blinks red, try "Method 2".
*1: WPS stands for "Wi-Fi Protected Setup
*2: " _ " stands for a digit that is unique to each set.
6
*3: Make sure that DHCP is enabled for the network setting on the iPhone.
RQT9655
.
1
status indicator
Wi-Fi ®
status
Wi-Fi ®
status indicator still turns
®
".
TM
Method 2
If your wireless network router does not support
WPS* .
1
With this method, you will access this unit's
wireless network settings from the Internet browser
of your compatible device.
≥ The illustrations and explanations are based on an
iPhone. However, the word "iPhone" can be replaced
with your compatible device.
Preparation
≥ Check your home wireless network name
(Network name (SSID)) and password for this
network. This can often be found on the wireless
router itself.
≥ Turn on your iPhone.
1
Press and hold [VOL +] and [– WPS] on
this unit for more than 2 seconds.
{. The Wi-Fi status indicator blinks purple.
®
2
Connect your iPhone to this unit's wireless
network called
"Setup _ _ _ _ _ _"*
2, 3
≥ Once "Setup _ _ _ _ _ _" is selected, the iPhone is
connected with this unit.
3
Start Safari on your iPhone and type
"http://192.168.1.12/" into the URL
address field and display the page.
{. This unit's setup window is displayed.
.