FRONT PANEL INTERFACE
–
Clearing the event records
–
Clearing the oscillography records
–
Clearing fault reports
–
Changing the date and time
–
Clearing the breaker arcing current
–
Clearing energy records
–
Clearing the data logger
–
Clearing the user-programmable pushbutton states
To enter the initial setting or command password:
1.
Press the
MENU
display.
2.
Press the
MESSAGE
3.
Press the
MESSAGE
4.
Press the
MESSAGE
appears on the display.
4
SECURITY
5.
After the
CHANGE...PASSWORD
selection to "Yes."
6.
Press the
ENTER
7.
Type in a numerical password (up to 10 characters) and press the
8.
When
VERIFY NEW PASSWORD
CHANGE SETTING
PASSWORD: No
CHANGE SETTING
PASSWORD: Yes
9.
When the
NEW PASSWORD HAS BEEN STORED
4.2.11 Invalid password entry
By default, when an incorrect Command or Setting password has been entered via the faceplate interface three times
within five minutes, the
level access via the faceplate interface for five minutes.
4-28
key until the
header flashes momentarily and the
SETTINGS
right arrow until the
ACCESS LEVEL
down arrow until the
CHANGE LOCAL PASSWORDS
right arrow until the
CHANGE SETTING PASSWORD
ACCESS LEVEL:
Restricted
CHANGE LOCAL
PASSWORDS
message appears on the display, press the
key and the display prompts you to
displays, re-type the password and press
ENTER NEW
PASSWORD: ##########
message appears, your new Setting (or Command) password is active.
FlexLogic operand is set to "On" and the C60 does not allow settings or command
LOCAL ACCESS DENIED
PRODUCT SETUP
message appears on the display.
message appears on the display.
or
CHANGE COMMAND PASSWORD
CHANGE COMMAND
PASSWORD: No
CHANGE SETTING
PASSWORD: No
ENCRYPTED COMMAND
PASSWORD: ---------
ENCRYPTED SETTING
PASSWORD: ---------
up or down arrow to change the
VALUE
.
ENTER NEW PASSWORD
key.
ENTER
.
ENTER
C60 BREAKER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES
message appears on the
message
VERIFY NEW
PASSWORD: ##########
NEW PASSWORD
HAS BEEN STORED