Installation
Notes on connections
• Turn off the power supply for all components before making any connections.
• If the cables necessary for connecting a component to the system are not included with the component or available
as an option, you may need to fashion a cable to suit the component concerned.
• Read the instruction manual for each system component carefully before connecting it.
• If there is a lot of jitter in the video signal input from the video source, the picture on the screen may flicker. In this
case, it will be necessary to connect a TBC (time base corrector).
Connecting the Antenna / Cable to the RF in Terminal (No VCR)
Antenna Connection
For proper reception of VHF / UHF channels, an external antenna is required. For best reception an outdoor
antenna is recommended.
VHF Antenna
Mixer
RF
Coaxial Cable
WARNING
When using "Nut type" RF coaxial cables, tighten with fingers only. Overtightening may damage terminals.
12
UHF Antenna
VHF/UHF TERMINAL
ON THE BACK OF THE
PROJECTION DISPLAY