Honeywell AlarmNet 7847i-E Installation And Setup Manual page 41

[X]
Reset CPU Y/N
[↑ ↑ ↑ ↑ ]
Registering ...
(UP arrow)
[↓ ↓ ↓ ↓ ]
Enter PIN#
(DN arrow)
[0]
Force Server Update?
Y/N_
[ENTER]
Strt Prog Mode?
Y/N_
Section 5: Programmer Keyboard Commands
Reset the 7847i/7847i-E
Pressing [N] returns to diagnostic mode (blank screen =
enter next command or escape).
Pressing [Y] resets the module (blank screen = reset
complete).
Registration
Registers a programmed 7847i-E with the 7810iR-ent if
it is configured to report on the Private LAN. If it is
configured to report to AlarmNet, the 7847i/7847i-E will
register with AlarmNet.
Registration.
Registration with PIN for Replacement Module
Registers a replacement unit with AlarmNet, once
programmed, using the existing PIN #.
If Private LAN is enabled, down arrow is not applicable.
Force Upload of Configuration File to Server
Pressing [Y] will force the device to upload its entire
configuration file to the server.
Pressing [N] cancels the operation.
NOTE: If Private LAN is enabled, "Function
Unavailable" is displayed.
Enter Program Mode
Press [Y] to enter program mode; otherwise, press [N].
Refer to Section 4:
5-3